So his body lines are stickers! Fair enough, it's hard to see it turning out any other way. Otherwise most of his stickers seem to be for his weapons, which is fair enough.

What interests me most though is this bit here -- they do indeed use a single sticker each for the eyes that just goes over the slats no problem apparently. The reviewer doesn't note anything about it according to auto-translated subs - only noting the slats were a bit tough to put in - so I'm very curious what magic is pulled off here.

https://i.imgur.com/UidknTF.png

https://i.imgur.com/bXbi75o.png

This sticker sheet is giving me Build PTSD. Too many parts with several colors on them that come as stickers. This is going to be a multi-day paint job.

It is the unpainted version, heres the sticker sheets tho

Honestly I'll just paint the black stripes, I messed up Build pretty bad due to the multicolor bs.

Am I missing something? The stickers look fine. What multicolor stuff are you concerned about? The Ridebooker?

edit: after watching the video, I think the worst stickers are the pink blocks on the sides of his bicep. They have to fold and conform and they really stand out to me.

The ride Booker, kneecaps, upper arm and just dealing with any crevices that have the black in them.

Edit: plus after watching a couple videos it looks like the upper leg part may have a wrap around black stripe sticker at the bottom. I'm sure there will be a couple more surprises as we see more.

Judging by the shapes of those pieces, I'm guessing the black bits that slot in sit totally flush with the rest of the head when they're clicked in properly, so the eyes are essentially one flat surface? And then it just looks like you can still see the slats through the stickers because of the sculpting on the clear pieces over top? I'm like 99% sure that's what's going on, but the effect looks so seamless in that video it's pretty impressive if that's really the case.

That pretty much is what is happening. Each piece has enough of a groove that once its placed in, it creates the slot for the visor perfectly, fitting the sticker. And the size of each slotting piece looks to be enough to sit flush with the head. So, you are right.

Also a question, is it possible to melt a clear plastic runner and reshape it? I have some hard clear yellow runner from faiz that i was hoping could be melted to make the yellow piece on decade's helmet. Would it be toxic? And are the markings for decades belts stickers, or waterslides?

It's just a triangle, right? You could probably just use nippers to get the piece you want. If that doesn't work, you probably have enough material from the Faiz visor for a couple attempts if you want to try to melt it down.

I mean i want to keep the visor cause i built the kit, but i have the runner left over. Idk how big the triangle will be on decade, so i just want to be prepared. If its super tiny, ill probably be able to get a piece for the triangle easily from the runner, but the area is so small, there are not many flat surfaces. Its also the smallest part of a multicolored runner, thats the problem.