[rego]

Quote:

Originally Posted by Dr Kain

Good to know. That kind of sucks. Does Bluefin know about this?

Is there any way to remove the figure without ripping the paint off the coat?

no idea if they know or not...it looks to be a case of the paint just not having enough "air time" to set fully. since its on a soft vinyl material it just stays tacky in the clam shell since there is no air escaping or coming in...its essentially zip locked for freshness inside.

the first time i tried removing mine it was stuck so bad i could not pull him from the tray. i had to warm the back of the tray behind him up so it would free itself without pulling at the coat in the process.

no paint damage seems to have happened doing this. im sure if i had just forced it i would have left some kinda of mark. you will know if you don't have fully set paint, the entire coat of the figure will leave a slimy feeling on your fingers =/

i had to leave mine out for a few days from packaging to remedy the issue to a point where it would no longer just re-stick itself when put back inside.