[raz]

Quote:

Originally Posted by Den-O

How did you get that off without damaging him?

I didn't, actually. You just can't see it.

Someone said to use a small screwdriver to undo the connectors on the shield. So, I got a small flat head, and it wouldn't pry them off. So, I started applying pressure pushing the shield away from him. After a few minutes of attempts, I managed to get a connector undone. I tried again and managed to get another on the other side off. I tried again and got a third off, and the strap on one side was able to fully come off.

I quickly found out it's glued, not attached. However, the shield is very hard plastic, so I can put the shield on a figuart and place the plastic band in between the two sides of the shield, and it holds it in place without snapping in or glue.

I also noticed I scraped some paint off back side of the green figure in the process. The shield would cover all that up though if I put it back on.