[Nrin Vakil]

Trying something new - and bigger. It's a material called Hydrospan, which will expand to 1.6 times the original, when left in tap water for a few days.

Here is the original cast after molding the Futabasaurus Minizord head (I also cut off the wheel from my cast):



Here is the model almost full size after soaking in tap water for around 24 hours. I believe it got a little bigger before I molded it:



Here is my first cast. I rotocasted to to make the piece hollow. My plan is to cut it apart and fill the upper and lower jaws with the connective guts from the Plesiozord head - both pieces are removable from the figure - akin to what I'm doing with Tapejara/Pterazord:



I'd also love to add the neck ribbing. But I'd have to be glue-on pieces rather this molding the whole darn neck apparatus. I've got enough work cut out for myself as it is...

I've been a bit ADD when it comes to finishing these zords. My best guess is that Fukuiraptor will be done next, followed by Tapejara, Iguanodon, and then Futabasaurus.

I don't yet have an extra plesiozord to work with...