[MaskedRiderAsakura]

Quote:

Originally Posted by IXRollOutIX

Depends on the tools at your disposal. I imagine if you have a dremel with a sanding tool it'd be a whole lot easier. You have to expand the hole on the Converge head a fair bit to allow room for the Souchaku's neck. Personally, I just widdled around with a hobby knife then wrapped some sand paper around a dowel before going to town and smoothing the cavity out. From there, you need to shave a little off the top of the peg which pulls out of the Souchaku's head so that there's enough room for it to completely fit inside the new one. Mine is just staying connected with friction and some putty, but you could probably work out a more permanent/solid solution than that.

So... moderate, I guess? Took me probably a couple hours in total.

Thanks! I'll have to try this. I just ordered a Souchaku Henshin Kiva.


Knowing my luck though, they'll end up announcing an S.S. one in a couple of days or something